CHAPTER 1: Testing Harmonized Protocols
Testing the voltage and power as function of current density: Polarisation curve for a SOFC single cell
JRS Scientific and technical reports
SOFC Single Cell Performance and Endurance Test Modules
JRS Scientific and technical reports
Testing the voltage and power as function of the current density: Polarisation curve for a SOFC Stack
JRS Scientific and technical reports
SOFC Stacks Performance and Endurance Test Modules
JRS Scientific and technical reports
CHAPTER 2: Testing Procedures from the Literature
SECTION 1: Projects
Thermal and current load testing results for Integrated Planar and short SOFC stacks – Birmingham experience within RealSOFC
Dr Waldemar Bujalski, University of Birmingham / REALSOFC - Project no. 502612, FP6-2002-ENERGY-1
Real-SOFC- A Joint European Effort to Improve SOFC Durability
Robert Steinberger-Wilckens Forschungszentrum Julich GmbH / REALSOFC – Project no. 502612, FP6-2002-ENERGY-1
Solid Oxide Fuel Cells (SOFC)
Dr Waldemar Bujalski, University of Birmingham / REALSOFC - Project no. 502612, FP6-2002-ENERGY-1
Definition of the ADEL testing protocol and revised test matrix
EIFER / ADEL - Project no. 256755, FP7-JTI
Testing method (DoE, initial test matrix and test protocol including required experimentation) incl. data analysis requirements
EIFER / DESIGN - Project no. 256693 FP7-JTI
Report on testing SCO tolerant ST cells towards P=0.4 W/cm2
TOFC / SCOTAS - Project no.: 256730, FP7-JTI
Application oriented functional / performance Test Program validation report including Test Program revision
Jens Mitzel (DLR) / STACKTEST - Project no.: 303445, FP7-JTI
International standard status report
Fabrice MICOUD, Sebastien ROSINI (CEA) / STACKTEST - Project no.: 303445, FP7-JTI
Application oriented safety / environmental test program validation report including test program report
Thomas Jungmann (Fraunhofer ISE), Jurgen Hunger (ZSW) / STACKTEST - Project no.: 303445, FP7-JTI
Application oriented durability test program validation report including test program release versions
Frederik Nygaard (DTU), Jurgen Hunger (ZSW) / STACKTEST - Project no.: 303445, FP7-JTI
Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - General SOC Testing Guidelines
Qingxi Fu (EIFER) / SOCTESQA - Project no.: 621245, FP7-JTI
Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - Start-up
Sune Veltze (DTU) / SOCTESQA - Project no.: 621245, FP7-JTI
Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - DELIVERABLE REPORT: List of SOC Test Procedures
T. Malkow (JRC) / SOCTESQA - Project no.: 621245, FP7-JTI
Solid Oxide Cell and Stack Testing, Safety and Quality Assurance - DELIVERABLE REPORT: Test Matrix Document
Qingxi Fu (EIFER) / SOCTESQA - Project no.: 621245, FP7-JTI
SECTION 2: Other Sources
Accelerated lifetime testing and standardization of SOFC systems
M. Naslund, H. Iskov / Danish Gas Technology Centre
Degradation testing – quantification & interpretation
Johan Hjelm / International Workshop on Degradation Issues in Fuel Cells, 21-23.09.2011, Thessaloniki, Greece
Solid Oxide Cell and Stack Testing, Safety and Quality Assurance (SOCTESQA)
C. Auer еt al. / E C S Transactions, 68(1), 1897- 1905
The Status of Home-Installed SOFC System Development at Osaka Gas
S. Inoue et al. / Fuel Cell Development Dept., Osaka Gas Co., Ltd.
Anode degradation mechanisms in SOFCs
C. Argirusis / International Workshop on Degradation Issues in Fuel Cells, 21-23.09.2011, Thessaloniki, Greece
A Comparison of US and EU Test Protocols
I. Bloom et al. / Argonne National Laboratory
Spatiotemporal simulation of nickel oxide and carbon phases formation in solid oxide fuel cells (SOFC)
J. P. Neidhardt et al. / German Aerospace Centre (DLR), Institute of Technical Thermodynamics
Degradation and Durability of SOFC Materials by the Impurities
T. Horita еt al. / Fuel Cell Materials Group, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, JAPAN
Mechanical properties and electrochemical durability of solid oxide fuel cells
Ke An / Virginia Polytechnic Institute and State University
Durability of anode supported Solid Oxides Fuel Cells (SOFC) under direct dry-reforming of methane
А. Lanzini et al. / Chemical Engineering Journal 220 (2013)254-263
Analysis of Percent On-Cell Reformation of Methane in SOFC Stacks: Thermal, Electrical, and Stress Analysis
K. P. Recknagle et al. /Pacific Northwest National Laboratory
CHAPTER 3: ENDURANCE Procedures and Protocols
SECTION 1: Testing
Single Cells Electrochemical Characterization Protocol
SOLIDpower/D. Montinaro
Procedure for Segmented Cells Tests at HTceramix for ENDURANCE
HTceramix
Protocol for Long-term Electrochemical Tests
CEA
Conditions for Long Term Tests of Short Stacks at CEA
CEA
Test Protocols for Long Term Tests at DLR
DLR
Test Protocols for Segmented Cells at DLR
DLR
Test Protocols for Long Term Thermal and Load Cycling of Short Stacks at DLR
DLR
Short Stack Testing Conditions at EPFL
EPFL
Recommendation for Measurements of Volt-Ampere Characteristics of Fuel Cells for Diagnostic Purposes
IEES-BAS
SECTION 2: Characterization
Protocol for SIMS Analysis at ICMCB
CNRS-BX
Protocol for Raman Imaging at ICMCB
CNRS-BX
Enhancement of the X-ray Nano-holotomography Protocol
CEA
Protocol on Inductively Coupled Plasma Optical Emission Spectrometry (ICP-OES)
EPFL
Protocol for Characterization and Post-test Analysis by SEM, FIB-SEM
EPFL
Protocol for Characterization of Thermo-mechanical Properties
EPFL
Procedures for glass sealant material investigations
UNIGE, SCHOTT AG
SECTION 3: Technological Improvements
Deposition of YSZ Barrier Layers on Steel for Interconnects
UNIGE/DLR
Protocol for Densification of a Thin Ceria-doped Layer by Infiltration of Solutions at ICMCB
CNRS-BX